The table shows the pin configuration of the Arduino UNO–based robotic arm. The red (VCC) wires of all servos are connected ...

Description: $2 for pcb Prototype, for more information visit: Download the codes here Arduino simple shield potentiometer ...

ACEBOTT QD023 is an ESP32-based wearable gesture control glove that tracks finger movements with potentiometers instead of more traditional flex sensors.

Here’s something fun from [Chad Kapper] over on HackMakeMod: Escape Room Lockbox with the Cheap Yellow Display. You may have heard of the “cheap yellow display” (CYD), so-called due to the board’s ...

Using the LMC555 CMOS analog timer to set a frequency from < 10Hz to > 100kHz, giving this design a strong dynamic range but ...

Professional mountain bike racing is a rather bizarre sport. At the highest level, times between podiums will be less than a second, and countless hours of training and engineering go into those ...

The AD5263 is a digital potentiometer with 4 channels and very much alike the AD524X (single / dual channels). This digital potentiometers come in 20, 50 and 200 kΩ and can be set in 256 steps. This ...

The MCP4261 library supports both hardware SPI and software SPI up to 10 MHz. These series of potmeters (rheostats) come in values of 5, 10, 50 and 100 kΩ (±20%). Where other potmeters uses a range of ...

Abstract: In this paper, a wearable sensing glove for measuring the motion of the fingers is proposed. The system consists of linear potentiometers, flexible wires, and linear springs, which makes it ...

Abstract: Reliable and efficient trajectory generation methods are a fundamental need for autonomous dynamical systems. The goal of this article is to provide a comprehensive tutorial of three major ...